BySpeed 3015 from 2010.
- Optimal access of the machine on the long side
- Easy and quick to place residual plates without danger to the operator and ideal for a quick job in between
- Limited number of actions required to be done by the operator and therefore higher productivity
- Fully covered working range, therefore minimum noise level
- A normal floor is sufficient, the machine does not need to be anchored
Drive system
- DHM direct drive system with low speed and high torque
- Great acceleration up to 3g
- Long service life due to low load on the bearings
- Closed and secured drives
- No coolant is required for the drive
- Self-braking system
- Only one drive per axle
- Accurate through a direct measuring system
Cutting heads
- Two heads or lens cassettes for the entire cutting thickness range
- Cutting heads can be changed quickly within seconds, without tools
- Integrated capacitive scanning
- CutControl for monitoring and controlling the cutting quality
Service
- Manual operator terminal for time-saving adjustment work
- Simple restart on contour with the hand terminal
Control ByVision
- Adjustment directly on the MMC operator terminal is possible
- Activate, deactivate and automatically apply microjoints without interfering with programming software
- Nesting parts from existing nesting plans
- Less loss of time at the end of the cutting program, fewer side times, higher productivity
Laser
- 4.4kW laser power
- Very low power consumption due to modern DC power generation
- Precise laser pulses make it possible to apply special cutting technologies such as: high-speed cutting, scanning, lead-in and controlled pulsed insertion CPP
- High efficiency
- Flexible layout through separate positioning of laser source