BySpeed 3015 from 2008.
- Operating hours: 109 000
- Cutting hours: 49 000
- Z-axis overhaul in October 2022
- 4.4kW CO2 laser source
- Turbine replaced in May 2019
- With ByCell Automation and warehouse with 2x 20 storage places
- Optimum machine access on the long side
- Simple and quick placement of residual sheets without danger to the operator – ideal for a quick job in between
- Minor extra actions for the operator and therefore higher productivity
- Fully covered working area, therefore minimal noise level
- A normal floor is sufficient, the machine does not need to be anchored
Drive system
- DHM direct drive system with low speed and high torque
- Great acceleration up to 3g
- Long service life due to low load on the bearings
- Closed and secured drives
- No refrigerant is required for the drive
- Self-braking system
- Only one drive per axle
- Precisely by a direct measurement system
Cutting heads
- Two heads, respectively lens cassettes for the entire cutting thickness range
- Cutting heads can be changed quickly in seconds, without tools
- Integrated capacitive sensing
- CutControl for monitoring and controlling the cutting quality
Service
- Hand-held terminal for saving time on setting work
- Simple restart on contour with the hand terminal
- Control ByVision
- Adjustment directly on the MMC operator terminal is possible
- Activate, deactivate and automatically apply microjoints without intervention in programming software
- Nesting parts from existing nesting plans
- Less time lost at the end of the cutting program, fewer downtimes, higher productivity
Laser
- 4.4kW laser power
- Very low power consumption due to modern DC power generation
- Precise laser pulses make it possible to apply special cutting technologies such as: high-speed cutting, scanning, lead-in and controlled pulsed insertion CPP
- High efficiency
- Flexible layout due to separate arrangement of laser source